Mini Brushless Servo Motor CW CCW DC 24V 6000RPM Built-in Driver Board Double Ball Bearing with 100-line Poelectric Encoder

Note: It is strictly forbidden to connect the positive and negative poles of the brushle motor to the wrong side. If they are connected incorrectly, the drive board will be burnt out. The brushle motor has a built-in driver board, which can support PWM signal speed regulation (duty cycle speed regulation), or connect PWM in parallel to GND, and the motor will run at the highest speed, so that only one set of DC power supply motors can run normally , It is very convenient to use, and there is an electronic brake on the drive board, which can support forward and re selection. The motor also has a 100-line photoelectric encoder, which is quite a miniature brushle servo motor. 1. Purple wire: positive power supply (+24V) 2. Blue wire: GND (PWM and the common GND of 24V and 5V) 3. Blue wire: brake wire, connect to GND to brake, and let it go in the air. 4. Orange red line: PWM signal, which can be connected to GND to run at the highest speed. 5. Yellow line: direction, when connected to GND, the direction is CCW, and the floating direction is CW. 6. White wire: +5V (power to the encoder, if you don't use the encoder, you can not connect it) 7. Red line: output signal A. 8. Blaline: output signal B. The following actual measurement uses the PWM signal to test the motor speed. This motor still has requirements for the pulse frequency of the PWM signal, the best 2000-10000HZ, and then the duty cycle can be used to control the motor speed. (Duty cycle between 0% and 90%) 90% 582 to 14 MA 80% 1056 to 23 MA 70% 1770 to 31 MA 60% 2380 to 38 MA 50% 2970 to 45 MA 40% 3570 to 52 MA 30% 4166 to 59 MA 20% 4800 to 64 MA 10% 5400 to 72 MA 0% 6000 rpm 81 MA ------------------------------------------------------------- Weight :120g The most ant thing for the brushle motor is to pay attention to the positive and negative poles and strictly prohibit wrong connection. There are other wires and also be careful not to touch the +24V terminal. Please carefully chethe wire sequence and then power on and test the machine. The driver board is broken. --------------------------------- Package Include: 1PCS * DC Motor About shipping
Shipping and PaAll itwill be double checked and well packed before sending.Itwill be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for remote areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resolve the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties or taxes. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very ant to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedbafor the transaction.