Water Heater Heating Immersion Screw Plug DN50 Stainless Steel 48V 900W

(each loophas 450w individually. Youwill get 48v 450w by connecting one loop, 48v 600w by connectiong 2 loops .) Thread: 1 1/4" BSP brass
APPLICATION:
1.Versatile usage in heating up water, such as RV's, boating, surfing, camping and even emergency Hypothermia treatment. Take a hot shower while tent camping or after surfing or scuba diving. Make emergency hot water for hypothermia or frost bite victims in the field.
2.These can be used to transfer waste vegetable oil into biodiesel, also for brewing and warming up liquids, etc
3.Perfect as a dump load for small wind turbines, it can be used to heat water in your water tank or hot water cylinder, also the same as to apply to solar panels.
4. Remember NEVER to heat your animals water with a high voltage. 48v is great for dogs, cats, horses, cattle to keeps water troughs and stock tanksfrom freezing in winter. By connecting one to a large 48v recharged by a large solar panel or wind turbine, just use a basic 5 degrees normally open thermostat and when the water temperature gets near five degrees the heater will automatically come on and warm the water by a few degrees before switching off again, one could also be used in the water storage tank.
5.These have been helping thousands of concrete mixing trucks and concrete business for a long time! Frozen water can put your crew out of business for the day! Use one or two elements depending on the size of the tank. DO NOT leave the tanks filled over night! Fill them with fresh water in the morning and then keep theheatingelement running in the tank all day long and your water will never freeze.
6.These can be wired directly to solar panels with a similar output to heat the water when the sun shines. It can be connected directly to a charge controllers 48v output but it would be better to get a high ampage relay and that by the controller and just use the relay as an inline switch between your ( )and the , high ampage cable and fuses should always be used when dealing with this sort of current, a simple on/off thermostat can be attached to the top of your tank to switch the off automatically when a certain temperature.

WARNING:
1.Do NOT run the tanks DRY with theheatingelement ON or it will burn up!You MUST always have them submerged in water at ALL times when they are powered up!
2.Do NOT use grid as it will immediately destory the .
3.If you are using 48 volts waterheatingelement, please use 48 Volt and vice versa.
Please kindly note the item comes withBSP thread. Customers from USA and Canada will need NPT threaded heater.

Note:
1.Pleaseallow1-3cmerrorduetomanualmeasurement.Pleasemakesureyoudonotmindbeforeyoubid.
2.Thecolorsmayhavedifferentasthedifferencedisplay,pleaseunderstand.










a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a