4 Pack LED Solar Panel PIR Motion Sensor Wall Light - Black

Remind
If the switch is not bright, it may be caused by no electricity. At this time.please expose the product to the sun for 3 hours,then try again.
2. Operational instructions
To use the solar wall lamp, just turn on the switch button. This switch only needs to be turned on once, It will be used in the future. No need to open it again.
3. Installation instructions
Please install the product on the wall or pillar with the screw provided by us. The optimum installation height is 2-3 meters.
When installing, drill holes first, then fix the product with screw.
4. Charging instructions
Install the product in a place where sunlight can be directly illuminated, preferably facing south,to ensure that there is no shadow or cover on the solar panel to block the sunlight.
(Normal first use requires more than three hours of exposure, and standard sunlight for seven hours can be full of batteries
5. Reasons for not bright or sensitive
1. The newly-arrived product itself stores less electricity.It needs to be exposed to the sun for more than three hours for the first normal use, and the standard sunlight can be filled with batteries for seven hours.
2. If the induction is not sensitive,it may be that the installation height of the product is too high. The optimal installation height of the product is 2-3 meters.

Notes:If there's sunlight or other lights on the solar panel, the lamp will not be on even if the ON/OFF switch has been turned on. During testing, other objective should be used to cover the solar panel,then the lamp will be on after turning on the ON/OFF switch.