Rq RELAY MODULE 3-5V 10A/250VAC

This is 1 Channel 5V Relay Board Module for Arduino PIC AVR DSP ARM. A wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it.

Each one needs 15mA - 20mA driver current and Equipped with high current relay: DC 5V / 10A, AC 250V / 10A Standard interface that can be compatible with microcontroller.

Specifications:

·       1 channel relay board

·       Operating Voltage 5V

·       Max Current : 20mA

·       Relay Contact Current Capacity at AC250V: 10A

·       Relay Contact Current Capacity at DC5V: 10A

·       One normally closed contact and one normally open contact

·       Triode drive, increasing relay coil

·       High impedance controller pin

·       Pull-down circuit for avoidance of malfunction

·       Power supply indicator lamp

·       Control indicator lamp

·       Indicator for Relay output status

·       Can Be controlled various appliances & other Equipment With Large current.

·       Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)

·       The module is compliant with international safety standards, control and load areas isolation trenches