915 Generation 05x2M Water Transfer Printing Film Hydrographics Hydro Dipping Decor Kit Snakeskin

Application range can be applied to the surface of the materails such as hardwarebrassironaluminumcopperetcwoodplasticABSPUPPPEPVCetcceramicglassetc
Applicable industries autos electronic productshousehold appliancedaily arts and craftsindoorfootwearsports apparatusetc
Tensile properties pattern is not easy deformation
Environment friendly it will not bring pollution to the natural environment
Not easy to fade waterproof enduring aesthetic appearance

Water transfer film also called transfer printing is a way to do the printing on the surface that is irregular which overcomes the problem facing offset printing that can not reach the ued and grooved face
Specification
colourblack
Water Operation Temperature 25-35 Celsius
Thickness 003mm
Size 50*200cm
PatternSnakeskin
MaterialPVA
How To Use
Base coating Mix the paint obtaining the color that you need
Film selections Select printing film that you need
P film Cut out the fit size p it flatly on water surface
Activation Spray the activator uniformly on the film after placing the film on the water 60-90 seconds
Transfer Keep 35 degrees with a fixture alignment film paper uniform downward pressure
Soaking About
Washing Remove the remaining film
Drying Remove the product' surface water
Storage
The film should be covered by plastic when A heavy dark trash bag is perfect
Film Storage 18-25 Celsius
Optimum Temperature 215 Celsius
Humidity 45-65%
Do not open until to use to prevent contact with the air Water Transfer Printing Film is a Hygroscopic Substance It has the of attracting and holding water molecules from the surrounding environment Do not near water or in the room where your dip tank is located
Avoid direct sunlight

Package Contents
1 x Water Transfer Printing Film

Only the above package content other products are not included
Note Light and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm