915 Generation 2000W 50A ZVS Low Voltage Induction Heating Board Power Supply Module Flyback Driver Heater Coil Heaters

VCC positive power supply 24V10A and above 48V50A do not use lead-acid batteries
GND negative power supply
Fan 48V after a single 24V in series
Drive output OUT put_A OUT put_B
Coil production 4-5MM for 24-48V winding the coil you can use a sallow tube to cover the copper tube to prevent short circuit during heating The more power the less

Notice
1 It is not possible to energize without connecting the coil or the high-voltage package
2 It is best to connect an air switch between the power supply and ZVS to prevent the power supply from by excessive current when the power supply is turned on
3 For the first use connect the coil and power on for 5-10 seconds to check whether the heat sink is hot if the power is too the heat sink will be seriously heated when the power supply is overloaded If it is too hot increase the number of turns
4 Use above 1000W to cool the copper pipe with water
ColourAs shown
MaterialPlastic metal

Package Contents
1 x induction heater Kit

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm