915 Generation ATU-130 150W 35-54MHz HF Automatic Antenna Tuner Shortwave Antenna Tuner Rep ATU-100 ATU100 PIC18F2520

ATU-130 is a 150w automatic antenna tuner Improved on the basis of ATU-100 hardware it is an universal type
Adopt PIC18F2520 MCU
Using 4pcs T94 magnetic ring inductors the coil above 1mm the withstand power is greater and the heat is much smaller than the one
Use HF32 10A HF33 5A relays similar to that for icom at130
Adopt 6KV high-voltage capacitor with low loss Miniature shortwave automatic antenna tuner

Parameters
Coverage frequency 35-54MHz
Tuning impedance range 5ohm-12Kohm
Tuning power 5-15W
Transmit power SSB 160w max
Maximum measurable power 180w
When the initial standing wave deviation is large it is recommended to use the SSB not more than 150w for a long time FT8 AM FM CW is not more than 100W When the deviation of the standing wave before adjustment is large reduce the power as appropriate
Size 38 x 88 x 155mm15 x 35 x 61inch without the size of protrusions
Power supply 11-14VDC power supply
Instructions
Connect the power cord to 11-14vDC power supply Connect a shortwave radio to the IN RF line of the automatic tuner The antenna is connected to the ANT of the antenna tuner M seat or quick socket With Am fm cw 6-15w well tuned within swr15 you can use high power
If the standing wave is too large and the tuning is not successful high-power transmission cannot be used because it may damage the antenna tuner or shortwave radio Please remove the fault and then transmit with high power
Good grounding is good for standing wave tuning If it is unconditionally grounded connect the grounding end of the tuner to the grounding of shortwave radios
Colourblackblue
MaterialMetal

Package Contents
1 x Antenna Tuner
1 set x accessories multicolor colors don't accept the specified color

Only the above package content other products are not included
Note Light reflection and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm