12V Stepper Motor Stroke 80Mm With Slider Motor For Diy Small Engraving Machine

wear resistant, high hardness, has a long service life.
Widely used for small devices such as equipment, engraving machine, etc.
DIY installation process can improve your hands-on ability.
The motor needs a A4988 driver (not included) to drive, and the motor can not directly connect to the power.
The maximum linear speed is 25mm per second.
Material: metal
Color: silver
Model: D8-MOTOR80
Rated voltage: 9-12V
Thread rod diameter: 3mm / 0.1in
Thread rod length: 90mm / 3.5in
Slider block stroke: 80mm / 3.1in
Drive mode: bipolar drive
Thread rod pitch: ±0.5mm / ±0.02in (Moving 0.025mm for one step, can use microstep driver if needs smaller)
Drive voltage: 12V DC
Current per phase: 800 ma/phase
Coil resistance: 15 10%Ω/phase
No.of phases: 2 phases
Step angle: 18 ./step
Excitation method: 1-2 phase excitation
Pull-out thrust: 500g above at 125pps
Max response frequency: 1600 pps above
Max starting frequency: 1100 pps above
Insulation class: class E
Insulation strength: 100V AC one second
Insulation resistance: 50M DC 500V
Operating temperature: 0℃~+55℃
Motor surface temperature: 80℃
Item size: 105 * 15mm / 4.1 * 0.6in
Item weight: 46g / 1.6ounce
Note:
The motor needs to be driven by the driver, not directly connected to the power.
Package list:
1 * Motor with Linear Slide
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.