170° Anti Fog Waterproof Car Auto Rear View Backup Parking Camera CMOS

Description:

1.Anti fog glass.

2.CMOS imaging sensor.

3. NTSC video system.

4.Embedded mounting in rear bumper.

5.Snap-in design, it is easy to install.

6.High sensitivity and low consumption.

7.High-definition and 170 degree wide viewing angle.

8.Water-proof, shock-proof and functions.

9.It helps to avoid incidents and accidents abrasion well.

10.Extra-low illumination of 0.5 for clear night vision.

11.Its simple and modest design and small size won't draw any attention.

12.This camera can give you a full sight of the back of your car when you are driving.



13.To protect your car from collision with invisible obstacle, choose a high definition and

good quality camera as ours.

14.Perfect solution to get rid of that poor rear view visibility on your car, boat, trailer, ,

truck or any vehicle that has no rear-view mirror or poor rear vision.

15.Connect to any type of with a composite yellow RCA jack for crystal clear resolution

mounted inside will fit into most vehicle key holes, no installation needed.



Specification:

Lens: 2.0cm

: Black

TV System: NTSC

S/N Ratio: >48dB

Net Weight: 128g

Water-proof: IP66

: 12V±10%

White Balance: Auto

Camera Size: 22*21mm

Sync. System: Internal

Video Cable Length: 6.0m

Video Output: 1.0Vpp, 75Ohm

Length Angle: 120~170 degree

Cable Length of Camera: 59cm

Scanning System: 2:1 Interlace

Supply Cable Length: 41cm

Image : Left-right mirror

High grade of waterproofing: IP66

Horizontal Resolution: 420 TV lines

Effective Pixels: NTSC: 510(H) * 492(V)

Current Consumption: No More Than 300mA

Image Sensor: CMOS 1/4 MT9V125 or PC1030,

Minimum Illumination: 0.2 / F1.8(0 with LED)

Storage Temperature: -30℃ to + 60°, 95% RH maximum

Operating Temperature: -20℃ to + 60°, 95% RH maximum

Electronic Shutter: 1/50 to 1/100,000 seconds, 1/60 to 1/100,000 seconds



Installation:

1.Mount the camera inside the keyhole of your vehicle.

2.Adjust the lens of the camera to its best position.

3.Connect cord to connect to your vehivle 12V system.

4.Connect the video output(yellow) of the camera to the display in your vehicle.





a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a