3.5" Inch 3.3V TFT LCD Display Shield Touch Screen Breakout Board Module with Touch Pen Compatible for OPEN-SMART

3.5" Inch 3.3V TFT LCD Display Shield Touch Screen Breakout Board Module with Touch Pen Compatible for OPEN-SMART

It can be used with OPEN-SMART AT328P MCU Development Board directly.

Link:AT328P Development R3 (CH340G) Board

Note: this display is 3.3V, it can not work (5V) directly, pls change the to 3.3V.

Description：

This is a 3.5 inch TFT LCD expansion board. This display has a controller built into it with RAM er, so that almost all work is done by the TFT.

It leads out the pins of the TFT and breakout pins pitch is 2.54mm, so the secondary development is easy.

With GPRS module, you can design your DIY phone.

With NFC module, you can create acce control syst with the photos show.

With voltage and current sensor, you can e oscilloscope.

- Can use it directly to display characters, graphics and BMP format images with the help of Micro SD card adapter module.

- Compatibility: Because the logic level is 3.3V, it is compatible for board 3.3V, you generally need to add a level conversion circuit if you use a 5V Board compatible for .

- Touch screen type: resistive touchscreen.

- Touch Pen: length is 9cm;

- Resolution: 400 x 240, 16-bit (262,000) color

- Display size: 3.5 inch;

- Operating voltage: 3.3V;

- Logic level: 3.3V;

- Operating current: the maximum is 135mA

- Bus interface: 8080-parallel interface (8 bit)

- IO Port Package: PAD is available, and the pin pitch is 2.54mm.

- LED pin can connect to external backlight control circuit to control the brightne of backlight. You can connect it to GND to turn on the backlight all day.

- Very suitable for dial photo frame, oscilloscope, function , system monitor

Package includes:

1 X display module