5110 84x48 LCD Display Module White Backlight For Arduino UNO Mega Prototype

Description:

5110 LCD Module, Arduino Compatible
You will Need: ( NOT Included in this Listing ! ) Set of Two 1K Resistors ( For Safe Operation ) Set of Four 10K Resistors ( For Safe Operation )

Pin Connections:

1. RST--------- reset.
2. CE------------ selection.
3. -----------data/commands choice.
4. DIN-----------serial data line.
5. CLK------------serial Clock Speed.
6. VCC----------, 3.3V (Positive).
7. LIGHT--------- backlight control terminal.
8. GND----------- negative.

Specification:

supply voltage: 2.7V- 3.3V
Backlight Supply Voltage: 3.3V
43.6mm x 43.1mm(width X height)
84 x 84 dot matrix LCD,can show 4 lines of characters, 12 Characters Per Line

Feature:

Uses Serial Peripheral Interface () to communicate with the microcontroller, 8 signal lines including and GND. different types of MCU (MicroController Unit) , such as Arduino, PICAXE, ARM, etc. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
LCD controller/driver has been bound to LCD so the overall footprint of the LCD Module is Kept as small as possible.
Has TWO Rows where header pins can be soldered for greater flexibility of use!
Low supply, the working current in normal situation is lower than 200μA,and has -down mode.

Package included:

1 x 84x48 5110 LCD Module with White Backlight








a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a a