e engine start to warm up vehicle fit for Toyota 4G APP control no need add one on push start

No need add one on start/stop,easy to install , for e engine start/stop

Product function introduction:This system does not need to install a one-on start function. It is easy to install and does not affect the car system. a special two-way cable to connect the male and female connector of the car ignition locker. There is no need to deal with the locker. Ar starting the vehicle, you can do e engine stop or step on the foot brake to turn off engine automatically,then the key to start the vehicle and drive normally.1. Main functions:e unlock, lock, open trunk, e start/stop engine, APP control the vehicle (optional APP control module)2. How to do e start?2.1 Pre and hold the e we sent loon for more than 3 seconds or above.2.2 Pre the unloon on the e car more than 5 times in 5 seconds. (Note: Need to connect the unlocking wire, please refer to the installation manual)2.3 APP e start function.3. How to stop the engine ar e start?3.1 Short pre the loon on the e we sent one time.3.2 Step on the foot brake3.3 APP to do e stop.Note :1. No one on start/stop function , only add e engine start/stop, lock, unlo,etc.2. Need p an ignition in the car if the car with engine anti-theft function.3.Attached 1 pcs e contoller (no paive keyle entry function)4.Only need connect engine start wire(+12V,ACC, ON ,START), GND, lock, unlock, foot brake wires to get engine start and lock/unlofunction, other wires is not neceary.

4G full netcom

Standard version is with 4G APP control module,