e start by e fit for Toyota H Hyundai KIA FORD MAZDA 4G or bluetooth APP no need add push start

No need add push on start/stop,easy to install , for e start by e controller

Product function introduction:This system does not need to install push on start . It is easy to install and does not affect the car system. a special two-way cable to connect the male and female connector of the car ignition locker. There is no need to deal with the locker. Ar the car e started ,the device will turn off engine while you step on the foot brake , then the key to start the vehicle and drive normally. If you insert key and turn it to ON before step on the foot brake , then engine will not turn off ,you can drive as in normal driving .1. Main functions:e start by e controller or APP (4G network or Bluetooth, you need buy additional APP module )e unlock, lock, open trunk, e start/stop engine by APP (With additional l APP module)2. How to do e start?2.1 Pre the unloon on the e controller more than 5 times in 5 seconds. (Note: Need to connect the unlocking wire, please refer to the installation manual)2.2 APP e start function. (Must buy additional Bluetooth or 4G module )3. How to stop the engine ar e start?3.1 Step on the foot brake3.2 APP to do e stop.(Must buy additional Bluetooth or 4G module )3.3 The device will turn off engine within 15 min if there is no any operation.How to install equment easily ?For a simple installing , it only need connect foot brake , unlopositive detecting wire and Ground, and plug two-way special ignite connector. No need connect other wires.How to look for unlopositive detecting wire ?For this wire ,There is no+12V under normal conditions, and there is a nsient+12V when pre unloon of e controller, you can find it on the cenl locking motor or other positionsNote : Ar e start , the door beca by e controller , recommend connect lowire , the device will loautomatically ar e start. And the r can do unloby key or APP (it need connect unlowire ) to entry the car.