Mini Air Compressor Kit Air-Brush Spray Gun Pon Oxygen Injection Airbrush For Nail Art o Craft Cake Mist Sprayer

Feature

1. One machine is multi-purpose.This one has red light, blue light, no Photon mode, you can choose your favorite mode for oxygen injection. This one is suitable for all skin types and improves dry skin.

2.Photon+ oxygen injection.4nm blue light mode, not only moisturizes the skin, but also deeply cleans, promotes the absorption of makeup, smooths fine lines and brightens the complexion. 630nm red light rejuvenates skin, accelerates cell growth and promotes collagen formation

3. Deep hydration.The 0.3mm nozzle is equipped with a high preure of 180kPa, which atomizes the nutrient molecules into nanoparticles, reaching the basal layer of the skin to better lock in moisture and brighten the complexion.

4. Nutrient function.Masks, toners, serums... can double the absorption of makeup and save the required amount. Just 2 drops of serum can be sprayed all over the face.

5. Built-in Type-C charging port, battery life at any time.The battery capacity is 900mAh, the charging time is 3-5 hours, and the use time is half an hour. No matter where you are, you can charge the oxygen injector with a power bank, computer, and more.

Operation

1.Open the cap up and add the water-based solution

2.Adjust the amount of fog

3.Long pre switch key, turn on and blue light on; pre it again, red light on; pre it again, light off

4.Pre and hold the spray switch and start enjoying

Notice

1.Do not use this product while charging.

2.The surface of the product can be wiped with a wet towel, but cannot be washed in water

3.To avoid bacterial contamination, it is recommended to wash the product with warm water or before use.

4.Skin care products with consistency such as eence should be diluted before putting them in the water tank, otherwise the nozzle will be blocked.

5.Add beauty liquid (except pure water), it needs to be cleaned in time to avoid the residual beauty liquid from clogging the nozzle

6.In order to avoid nozzle blockage, after each spraying, you should: ①Pour out the remaining liquid in the water tank; ②Add clean water to spray (until no water sprays out);③Dry the water tank naturally or dry it with cold water (note that hot air and high temperature drying)

Warning:

When removing the water tank, the device must be turned upside down and then unscrewed. Otherwise, the solution in the tank will flow into the machine and the machine.

Specification

Item Type: Photon oxygen injection

Color: Black, Blue

Material: ABS+PC

Input voltage: 5V/1A

Power: 8W

Preure value: 180kPa

Atomization flow: About 0.012mm

Water tank capacity: 35ml

Nozzle diameter: 0.3mm

Battery capacity: 900mAh

Charging time: 3-5H

Using time: 30min

Product Include

1* Main machine

1* Water tank

1* Type-C data cable

1* Manual

1* Box