Portable IR Infrared Obstacle Avoidance r Module For Arduino Smart Car 3 Wire Reflective Photoelectric New

Features:

The r module light is adaptable to the environment, it has a pair of infrared transmitting and receiving tube, tube infrared emit a certain frequency, when detecting direction meet with obstacles (reflecting surface), reflected infrared receiving tube, after the comparator circuit proceing, green indicator will light up, at the same time signal output interface to output digital signal (a low level signal), can be through the potentiometer knob adjust the detection distance, effective distance range 2 ~ 30cm, working voltage is 3.3V to 5V. The r detection range can be through the potentiometer to adjust and have small interference, easy to aemble, easy to use, etc, can be widely used in obstacle avoidance, obstacle avoidance car, line count, and black and white line tracking and so on many occasions.

Module parameters:

1. when the module detects obstacles in front of the signal, the green indicator on the circuit board light level and at the same time the OUT port output low level signal, the detection module from 2 ~ 30cm, 35°detection Angle, test distance can be adjusted through the potentiometer, adjustable potentiometer clockwise, the detection distance increases; Counter-clockwise tuning potentiometer, detection distance is reduced.

2. rs, active infrared reflection detection, therefore the reflectivity and shape of the target is the key of the detection range. White one black detection range, minimum maximum; Small area of the object distance, large distance.

3. the r module output port OUT can be directly connected to the microcontroller IO port can, also can drive a 5v relay directly; Connection mode: the VCC - VCC; GND - GND; The OUT - the IO

4. the comparator USES the LM393, working stability;

5. can be used for 3 to 5V DC power to power supply module. When power on, the red power indicator light lit;

6. 3 mm screw holes, easy fixed, installation;

7. circuit board size: 3.2cm*1.4cm

8. each module is shped already compare threshold voltage through the potentiometer to adjust good, not special cirstances, please do not arbitrarily adjust the potentiometer.

Module interface specification:

1 . VCC voltage is 3.3V to 5V converter (which can be directly connected to 5V single-ch microcontroller and 3.3V)

2. GND external GND

3. OUT of small plate digital output interface (0 and 1)

Package Included :

1 x Module

Note :

If you have any question, please contact us before leave negative feedback, we will try our best to serve you, thank you for your understanding!

About shping
Shping and Pack All it will be double checked and well packed before sending.It will be dispatched within 2 business days after buyers pay for the order. It usually takes about 14 to 18 working days for delivering the package to the destination(for e areas,it may take a little longer). 

Special Announcement:
Please fill in the correct and detailed consignee, address and phone number in the order. For fast and correct delivery.If you do not receive order within 30 working days,please feel free to contact Customer Service before leaving Negative and Neutral Feedback, we will do our best to help you resoe the problem.TaxNo, you will only pay what is quoted as total cost at checkout, no more. You are not expected to pay any additional duties or taxes. If you are asked by Customs or our logistic partner to pay duties, please contact our Customer Service .

Your 100% satisfaction is very ant to us
If the product is not on good condition, You can return this product within 14 working days, please contact customer service center before returning.FeedbackYour satisfaction is our first priorityIf you receive the order and it is in good condition,we would be grateful if you would leave us 5 star Positive Feedback for the transaction.