TC-T7-H LCR-TC1 LCR-T4 Transistor For Diode Triode MOS/PNP/NPN Transistor Replace LCR-TC2

Type1

Features:

It can be widely used to detect NPN and PNP transistor, , , diode, triode, N-channel and P-channel MOSFET, IGBT, JFET, triac and battery etc. It can also be used to detect infrared wave forms. It also can detect zener diode and has the function of self-calibration. After detection, align the infrared e control with the "IR" light, then pre the on in the e control, if the detector succefully decode it, it will display the data code and infrared wave form. One on operation, automatically detect and shutdown, and you can pre the multi-functional on to close the detector too. Put the pins of component in corresponding area, then dial the little handle and the detector will test it automatically, finally the results will display on the backlight TFT screen clearly. Not like the usual black and white display, this detector will show results in color. Highlight: 1.Transistor Automatic detection of zener diode  0.01-30V Self test with automatic calibration 2.IR decoder Support Hitachi IR coding IR waveform display Infrared receiving instruction 3.Other Features Measurement results using TFT graphic display(160x128) One key operation Auto Power Off(Timeout Settable) Built-in high capacity rechargeable Li-ion Battery Li-ion Battery voltage detection Support Chinese and English Specifications: Display: 160*128 TFT Screen Diode Range:  < 4.5V Zener Diode:Transistor Detect Area:  0.01-4.5V Zener Diode Detect Area:  0.01-30V Triac Range:  IGT < 6mA Capacitance:  25pF-100mF :  0.01-50MΩ Inductance:  0.01mH-20H Battery: 0.1-4.5V Power Mode: Rechargeable Lithium Battery ( INCLUDED) Item Size: 8.8 x 8 x 2.8cm / 3.47 x 3.15 x 1.10in Item Weight: 111.5g / 3.94oz

Operating Instructions:

1.Multi-function key has two actions: Short pre: Pre the key and not le than 10 ms, release key within 1.5 seconds Long pre: Pre the key more than 1.5 seconds 2.Power on: In the power off state, short pre the multifunction key, the is turned on and automatically measured. 3.Power on & measurement interface: 4.Detect transistor: In the power off state or the test is completed, put the test element into the transistor test area of test seat, and pre the locking handle, short pre the multifunction key, the automatically measure, graphical display of measurement results when testing is complete. Warning: Always be sure to DISCHARGE s before connecting them to the ! The may be damaged before you have switched it on! Warning: We do not recommend using the to measure the battery! The battery voltage must be le than 4.5V, otherwise the may be damaged! Performance : Multifunction can automatically identify elements and automatic detection of pin layout, and automatic switching range. The main performance are as follows:

Component

Range

Parameter Descrtion

BJT

-

hFE(DC Current Gain), Ube(Base-Emitter Voltage), Ic(Collector Current), Iceo(Collector Cut-off Current (IB=0)), Ices(Collector short Current), Uf(Forward Voltage of protecting diode) ③

Diode

Forward Voltage